Comment: I just bought the heated jacket liner, pant liner and Insoles. I have had the gloves for a while. I was skeptical about the heated insoles. My feet are so warm. My ride to work is an hour early in the mornings with the temperature in the 30's. I love these, the whole setup.
Tour Master Synergy 2.0 Heated Insoles
Comment: The Tour Master Synergy 2.0 Heated Insoles work great!!! And Jafrum also works great, I had some returns (size issues) and they were completely on top of it!!
lil piggys in a blanket
Comment: I was not sure how these would work but have found that if you hook these up with same tstat as gloves it does a great job. If you hook them up with jacket it is not enough heat. My lil piggys stay comfortable in any temp when in line with gloves.
The Synergy 2.0 Electric Heated Insoles have elements throughout the entire
insole so your whole foot stays nice and warm. They are unisex, machine washable
and available in shoe sizes 7-14. These insoles are weatherproof and are
designed to be used individually or in conjunction with the heated pants. Like
the gloves, these don't come with a controller. So, if you are planning on
wearing these without the heated pant liners, remember to purchase a power lead,
an extended v-splitter, and a controller. To wire your insoles into your heated
pant liners, simply plug the connector from the insole into the connector on the
cuf of the pant leg and you're ready to go. To use insoles by themselves, or in
conjunction with the chap liners, simply install the power lead to your battery.
Remember to install accessory leads beneath your motorcycle's battery cable ends
whenever possible. This will keep you from cracking the accessory terminals when
you torque down the battery hardware and also reduce the the chance of your
battery hardware coming loose. Next, run the extended v-split connector through
the legs of your pants and out the cuffs. Connect the insole connectors to the
splitter connectors. Connect the upper v-splitter connector to either a dual or
single Rheostat controller. Once you've started your motorcycle, you can connect
the controller to the power lead and set the Rheostat to the desired heat